Carbon Parts / Complete Systems

Building a boat can sometimes be stressful, specially if you are chasing those final parts or trying to figure out what to put in your boat. We have made it simple, and put together a package that will just require your own hull and the electronics you choose to install.

Example below is a configuration for MHZ 138. You can of cause pull any components out.

Carbon Fiber Parts
Dual 6mm Motor Mounts - $145
Servo Mount with stand off's - $110
ESC Top Plate Cover - $120 -
Lipo System with Custom Engraving - $285
Stuffing Tube Supports for 12mm Carbon Tube - $35

TOTAL $695

Hardware
Rudder - $185
Rudder Block Adaptor - $55
Hydraulic Pull/Pull System - $65
MK4 Long Drives - $385
Servo to Rudder Pull with 25 Teeth Spline - $65

Total $755

MK I Rear Pedestal Blocks (optional for extra long drives) - $95 USD | 87 EUR

Servo mount with stand off's

This Servo Mount has been designed to suit the most extreme conditions. Very easy to install with the supplied feet and M4 stainless spacer nuts.

MHZ138 / HPR135 Servo Mount with stand off's - $110
MHZ114 / HPR115-5009 and other 45" hulls - $95
 

"The Platinum Stamp" is the best we have to offer, it gives you assurance that you are dealing with high quality parts

Motor Mounts

These Motor Mount has been designed to suit the most extreme conditions. x2 (3mm mounts) create a solid 6mm mount that will survive any crash! There is no need for a rear support with these mounts, making the boat even more slick.

MHZ138 / HPR135 Motor Mounts - $145
MHZ114 / HPR115-5009 and other 45" hulls - $115

Lipo System

Exclusive custom engraved Lipo Sliding system. No If or butt's, this is by far the way to install lipo's in your boat. With enough travel to adjust CG perfectly, and pull out the batteries in seconds, this system is a must for any build. It can be customised to any hull in any size.

MHZ138 / HPR135 Lipo System - $285
MHZ114 / HPR115-5009 and other 45" hulls - $155

Tube Supports

These Carbon Stuffing Tube Supports are designed to HOLD! They can be adjusted while the tube and cable is installed and you find the perfect position. Once the adjustment is done, you simply fill in the pockets/cavity with epoxy and let it cure.

General 12mm carbon tube for 50" plus size Tube Supports - $35
General 10mm carbon tube for 50" below size Tube Supports - $35

Xcat 42" version

This carbon system is the perfect fit for your smaller 42" version of the MHZ Xcat. Designed to hold up to 400A MGM ESC's or SEAL ZTW 300A, or any other esc on the market

Full KIT including servo arms - $775

 Accepted